For most drivers, reversing and manoeuvring are the „necessary evil“ of driving. But this really needn‘t be the case. If you own a ŠKODA Superb, then the reversing camera from the ŠKODA Genuine Accessories range is the one for you. It makes reversing and manoeuvring much easier. You no longer have to worry about wrongly judging the distance between you and the car behind you, or even that you can‘t see something below your rear window. This is thanks to the special addition to the rear parking sensors, whereby the driver is able to see what‘s going on behind the vehicle on the navigation system‘s screen. This functional, user-friendly set is exactly the same as the product version fitted as standard. The reversing camera is fitted in the boot release handle and therefore keeps a very low profile. To integrate the camera, the vehicle must have a navigation system.
Specification of product:
Set contents: Handle with reversing camera, complete electrical wiring harness, connector, cable tie, foam rubber damping piece (2x), fitting instructions.
For fitting, the following components must be ordered from the ŠKODA Genuine Accessories range:
For the ŠKODA Superb Limousine (3V3)
Complete wiring harness for the boot lid / 3V0 054 634B
(instalation time: 300 TUs)
For the ŠKODA Superb Combi (3V5)
Complete wiring harness for the boot lid / 3V0 054 634C
(instalation time: 300 TUs)
Using: The camera is automatically activated when the vehicle is shifted into reverse gear. The camera simultaneously displays the area behind the vehicle and guide lines corresponding to the width of the vehicle. The camera display is a mirror image. As an aid to the driver, the navigation system‘s screen shows guide lines (trajectories) that make it easier to judge the distance when parking. The camera features a parking assistant, which shows the driver a parking space of the required size behind the vehicle and then provides them with parking assistance.
Designed for:
Only for left-hand drive vehicles produced from CW 22/2016 until CW 14/2018. The set is designed for vehicles equipped with the MIB Amundsen, Bolero or Columbus system.
Notification: This part is not compatible with the electronics of vehicles produced in Russia (Kaluga, Nizhny Novgorod).
EUR
GBP
